penis pumping with heat

Hungthespian · Mar 2, 2024

Hi All, I've recently started pumping and heard that heat application can really help accelerate gains. I'm 6.7 inches length and 5.7 to 5.8 in girth. I use a 2 inch cylinder and pack it out quite quickly. My length in the pump goes to 7.7 inches at 5hg/6hg. I have started on a routine of 2 x 15 min sets with an infrared heat pad wrapped round the cylinder. When I come out of the cylinder my cock is evenly engorged and I put on a cock ring for pretty much the whole day. I use a size that does not restrict too much blood flow but also tight enough to ensure I stay engorged. I want to hit 8.5 inches in length and 6.5 in girth. that for me would be an amazing penis.

I am pumping for length mainly and like @DLD says the penis is a balloon so I'm hoping for gains in all directions. Just wanted some advice on this routine and if any experienced vets have any suggestions to adding to this routine. I do also have a 3 inch cylinder and everyither day I do a 20 min cock and ball pump to further stretch all the ligaments. I will measure in 6 months and report back on any gains, but I have noticed that my cock is heavier and thicker. Also the night time erections are insane as is the morning wood.

squirt_inducer_man · Mar 2, 2024

I would suggest pumping with water.

Hungthespian · Mar 2, 2024

I do have a bathmat and sometimes will use that in the morning for 20mins and then in the afternoon do the routine above. however with the bathmats there is no gauge. but I can easily adapt my air pump with water with a simple brake bleed kit. what are your thoughts on @squirt_inducer_man on expressive stretching with a pump attached?

squirt_inducer_man · Mar 2, 2024

Hungthespian said:
I do have a bathmat and sometimes will use that in the morning for 20mins and then in the afternoon do the routine above. however with the bathmats there is no gauge. but I can easily adapt my air pump with water with a simple brake bleed kit. what are your thoughts on @squirt_inducer_man on expressive stretching with a pump attached?

I would not do that with my Bathmate pumps, even when @DLD developed a routine for that.

I payed a lot of money for my Bathmate pumps (even if I didn't pay full price for them).

But I have seen picures of a Bathmate pump break, and the gator was dislodged from the cylinder.

I don't know what this user did to it?

I like to separate length work and girthwork fully, and I can't do length work and girth work at the same time (the temporary expansion from girth work lasts to long).

That's why I'm using a Bathmate® HydroExtreme 7 Wide Boy (later I will use Bathmate 9 and MityVac, 2.5" cylinder). If I would try expressive stretches with a pump attached, by balls would get crushed.
- Are you not risking loosing the seal?

But it seams to work for some people. But my mindset is:
- Why even try when you have LengthMaster 3, to "pull out" penis with.

DLD · Mar 2, 2024

Many people try to save Money by buying a invitation bathmate. Only to realize they've wasted their money because they break. And they don't have the same quality as what we sell in the store

squirt_inducer_man · Mar 2, 2024

DLD said:
Many people try to save Money by buying a invitation bathmate. Only to realize they've wasted their money because they break. And they don't have the same quality as what we sell in the store

You should not save money. Better to get quality equipment right away.

It's bad because they do not question these people on Reddit, they just assume it's a genuine Bathmate®.
So no more r/Bathmate (on Reddit) for me.

I tried to recruit members from there, but it didn't work.

DLD · Mar 2, 2024

squirt_inducer_man said:
You should not save money. Better to get quality equipment right away.

It's bad because they do not question these people on Reddit, they just assume it's a genuine Bathmate®.
So no more r/Bathmate (on Reddit) for me.

I tried to recruit members from there, but it didn't work.

Exactly 💯

Hungthespian · Mar 2, 2024

Yeah I never do expressive stretching with the bathmate as it’s impossible to tell the pressure and I feel it’s better to have a working penis rather than a broken one 😜

I wanted to know if using my mitivac for expressive stretching was ok, as I can keep an eye on the pressure and minimise any injury.

DLD · Mar 2, 2024

That is why the mityvac is so powerful

oldandlively · Mar 2, 2024

squirt_inducer_man said:
I would not do that with my Bathmate pumps, even when @DLD developed a routine for that.

I payed a lot of money for my Bathmate pumps (even if I didn't pay full price for them).

But I have seen picures of a Bathmate pump break, and the gator was dislodged from the cylinder.
View attachment 1835344
I don't know what this user did to it?

I like to separate length work and girthwork fully, and I can't do length work and girth work at the same time (the temporary expansion from girth work lasts to long).

That's why I'm using a Bathmate® HydroExtreme 7 Wide Boy (later I will use Bathmate 9 and MityVac, 2.5" cylinder). If I would try expressive stretches with a pump attached, by balls would get crushed.
- Are you not risking loosing the seal?

But it seams to work for some people. But my mindset is:
- Why even try when you have LengthMaster 3, to "pull out" penis with.

I believe I know what happened. The gaiter baffles is a tight unit fitting with a bit of silicone adhesive applied with a bit of sealing pressure under a heating unit. I've seen similar assemblies for drink dispensers with CO2 gaiter baffles for restaurants.

Do remember that the silicone glue is not epoxy. It wasn't meant to deal with dropped (impact dislodgement), high heat (no more than 135F), and counter forces (twisting under tension). Using a combo of slightly hot water, high humidity, dropped a few times before, and twisting hard to get comfortable like the most of us, it will come apart. Best is to completely the pressure seal, adjust, and repump to prevent this from happening.

DLD · Mar 3, 2024

Gottila Glue

squirt_inducer_man · Mar 3, 2024

oldandlively said:
I believe I know what happened. The gaiter baffles is a tight unit fitting with a bit of silicone adhesive applied with a bit of sealing pressure under a heating unit. I've seen similar assemblies for drink dispensers with CO2 gaiter baffles for restaurants.

Do remember that the silicone glue is not epoxy. It wasn't meant to deal with dropped (impact dislodgement), high heat (no more than 135F), and counter forces (twisting under tension). Using a combo of slightly hot water, high humidity, dropped a few times before, and twisting hard to get comfortable like the most of us, it will come apart. Best is to completely the pressure seal, adjust, and repump to prevent this from happening.

You should not abuse your Bathmate pumps. Non of my 3 Bathmate pumps have this issue.

92tmorgan · Mar 5, 2024

Hungthespian said:
Yeah I never do expressive stretching with the bathmate as it’s impossible to tell the pressure and I feel it’s better to have a working penis rather than a broken one 😜

I wanted to know if using my mitivac for expressive stretching was ok, as I can keep an eye on the pressure and minimise any injury.

What exactly is expressive stretching with the mityvac?

DLD · Mar 5, 2024

92tmorgan said:
What exactly is expressive stretching with the mityvac?

Look at the video hardcore stretches

squirt_inducer_man · Mar 5, 2024

92tmorgan said:
What exactly is expressive stretching with the mityvac?

Bathmate routine | DLD hardcore stretches and girth

Bathmate RoutineGet yourself 100% erect and attach the Bathmate. I like to use water in the chamber; this Bathmate routine can be done dry if the proper pressure can be found or in the bath or shower.Pump up to high pressure. You will want enough suction that you can pull on the Bathmate with...

shop.mattersofsize.com

DLD · Mar 5, 2024

squirt_inducer_man said:
Bathmate routine | DLD hardcore stretches and girth

Bathmate RoutineGet yourself 100% erect and attach the Bathmate. I like to use water in the chamber; this Bathmate routine can be done dry if the proper pressure can be found or in the bath or shower.Pump up to high pressure. You will want enough suction that you can pull on the Bathmate with...

shop.mattersofsize.com

Thanks SIM

squirt_inducer_man · Mar 5, 2024

DLD said:
Thanks SIM

You're welcome.

penis pumping with heat

Hungthespian

Active member

squirt_inducer_man

Also called: SIM

Hungthespian

Active member

squirt_inducer_man

Also called: SIM

DLD

doublelongdaddy

squirt_inducer_man

Also called: SIM

DLD

doublelongdaddy

Hungthespian

Active member

DLD

doublelongdaddy

oldandlively

Well-known member

DLD

doublelongdaddy

squirt_inducer_man

Also called: SIM

92tmorgan

Active member

DLD

doublelongdaddy

squirt_inducer_man

Also called: SIM

Bathmate routine | DLD hardcore stretches and girth

DLD

doublelongdaddy

Bathmate routine | DLD hardcore stretches and girth

squirt_inducer_man

Also called: SIM

Forum statistics

Latest posts

Newest members

penis pumping with heat

Active member

Also called: SIM

Active member

Also called: SIM

doublelongdaddy

Also called: SIM

doublelongdaddy

Active member

doublelongdaddy

Well-known member

doublelongdaddy

Also called: SIM

Active member

doublelongdaddy

Also called: SIM

doublelongdaddy

Also called: SIM

Forum statistics

Newest members

Stay Connected